K2 Industries

2016-2018 Hyundai Tucson AC Condenser - Aluminum

$119.99 USD

~~$150.00 USD~~ $119.99 USD

Sale Sold out

Shipping calculated at checkout.

Product variants

Quantity

2016–2018 Hyundai Tucson AC Condenser — Aluminum

Direct-fit aluminum condenser engineered to handle full cooling demand for your Tucson's climate control system. Built with corrosion-resistant aluminum construction and precision tube-and-fin design for efficient heat rejection. Drop-in replacement that restores factory cooling performance without modification.

✓ Ships from FL Warehouse ✓ In-House Quality Check ✓ Factory Mounting Points

Key Features

Aluminum core with brazed tube-and-fin construction - Maximizes heat transfer efficiency and resists corrosion from road salt and moisture.
OEM-equivalent capacity and dimensions - Matches factory condenser output for consistent A/C performance without system recalibration.
Factory connection points and mounting tabs - Bolts directly to original brackets; no drilling or fabrication required.

Specs

Material: Aluminum
Construction: Tube-and-fin core with brazed connections
Condition: New
Quantity: Single unit

Whats Included

AC Condenser assembly only

Frequently Asked Questions

Will I need to recharge the refrigerant after installation?

Yes. Once you install the condenser, the system will need to be evacuated and recharged with refrigerant by someone with an EPA-certified manifold gauge set. Moisture and air enter the system during replacement, so a proper recharge cycle is essential for performance and component longevity.

Do I need any fittings or adapters to connect this to my existing lines?

This condenser uses factory connection points that match your Tucson's OEM refrigerant lines. No adapters needed — the existing inlet and outlet fittings bolt directly on. Confirm line compatibility before ordering if your vehicle has been modified.

What prep work is required before I install this?

Disconnect the negative battery terminal first. Drain any remaining refrigerant safely (required by law) using a certified recovery machine, then unbolt the old condenser and remove it. Clean the mounting area of any debris. The new unit installs in reverse order — no sanding, painting, or pre-treatment needed on the condenser itself.